Flooring Repair Eagle Idaho - Engineered Hardwood, Large-Format Tile, and Heated Floors

It depends on the wear layer thickness. Engineered hardwood has a real wood veneer over a plywood core. The wear layer ranges from under 2mm in lower-cost products to 4mm or more in premium products. If the wear layer is under 2mm, sanding will cut through to the core and the floor must be replaced. If the wear layer is 2mm or more, a light sand and refinish is possible. We measure the wear layer at the damaged location to give you a factual answer before any work is quoted.

First we check whether the tile lot is still available from the original supplier. Eagle custom home tile is often imported or from specialty suppliers who retain stock for several years. If the original lot is unavailable, we source the closest visual match and compare samples under your kitchen lighting before ordering. Grout color is matched by comparing dry samples under the actual room light. The replacement is installed and grouted to match the surrounding installation as closely as possible.

Yes, with careful work. We test the electric mat resistance before starting to confirm it is functional. During tile removal, we use an oscillating tool rather than a chisel to minimize lateral stress on the mat wires beneath the mortar bed. If the mat is non-functional before we start, we advise on mat replacement as part of the tile repair scope. We do not remove heated floor tile without a prior resistance test and explicit discussion of the mat risk with the homeowner.

Stain matching is done by preparing test blends on a scrap piece of the same species under the same finishing conditions. We blend tints into the base stain until the test piece matches the existing floor under the room's actual lighting. The blend is documented before application. We apply the matched stain to the replacement board after it is installed and acclimated, then finish with the same topcoat sheen as the existing floor.

Yes. The ANSI standard for large-format tile (tiles with any side over 15 inches) requires the subfloor to be flat within 1/8 inch per 10 feet. For standard tile it is 3/16 inch per 10 feet. A subfloor that does not meet this tolerance produces tile that rocks on high spots and cracks over low spots under point loads. We check subfloor flatness before any tile work and self-level or grind to tolerance before installation.

Yes for standard crack and grout repair. Surface scratches on polished travertine are addressed with stone honing compounds. Through-cracks require tile replacement. Travertine sourcing for replacement in an Eagle foyer requires identifying the quarry origin and fill pattern of the existing tile. If the original tile source is unavailable, we advise on whether a close visual match exists or whether a different repair approach (filling the crack with color-matched epoxy) is more practical.